I know that if you receive a big amount of data over Tor, like when downloading something, you will stick out and it’s possible for an observer to analyze where that traffic is probably going to.
But what is actually a safe limit for the data/second value?
Like is it
0.1mb /s, 0.5mb/s, 1mb/s, or Xmb/s?
If there was an option in Tor to limit data/second, how would you set it?
Assuming that a global adversary is correlating uploads and downloads across Tor, I would recommend running a Tor relay (non-exit) in addition to a Tor client. Match the bitrate settings on both the Tor relay and the Tor client, and in the file “torrc” use something similar to the following:
BandwidthRate 3072 KBytes
BandwidthBurst 4096 KBytes
Additionally, on the Tor relay, add the following to the file “torrc”:
RelayBandwidthRate 3072 KBytes
RelayBandwidthBurst 4096 KBytes
The goal of simultaneously operating a Tor relay is digital chaff, also known as cover traffic, for the Tor client.
Ideally, run the Tor client on a separate host / computer / virtual machine than the Tor relay.
There are other techniques to generate automatic digital chaff, but that is not something I wish to disclose.
2 Likes
What would be the privacy situation, not I just change the settings in the client, without cover traffic?
And can I make such changes on Android Tor Browser?
Sorry, but on Android I use Orbot not Tor Browser for Android.
How do I set a bandwidth limit on Orbot?
And is it safe even if I don’t generate chaff? I could also set it to something that is a common limit, like for example low tier WiFi/cellular contracts.
@Malachi, there is no completely safe | secure | private. The digital chaff will allow a Tor user to better hide in the noise of encrypted traffic.
Most of my work is in Tor for Linux, but I looked through the Orbot settings.
Untested, but it appears that you can edit the “torrc” and limit the speed in Orbot.
Start Orbot.
In the lower-right corner, click the ellipsis (settings).
Click the button “Orbot Settings”.
From “Orbot Settings”, click “Debug”.
From “Debug”, select “Torrc Custom Config”.
Hopefully, from there you may be able to configure the speeds you wish.
With all that being said, I do not think limiting the client speed adds any value without sufficient digital chaff. Also, operating a Tor relay from an Android smartphone is not advised (reliability, data cost).